How to make a spinner

Good day to all. In this article I will tell you how to make a simple toy spinner - spinner. Everything is done very simply, and most of the materials can be obtained completely free of charge.
How to make a spinner

For this we need:
  • Sleeves 5.45 (I scored my own in a military dash, although you can find it on any training ground or order it online).
  • ABEC 5 bearing (Ideally, ABEC 7, was extracted from the wheel of an old skateboard, can also be found in the auto shop or ordered on AliExpress).
  • Wooden bar (Any solid wood, in this case specifically - walnut).
  • Epoxy resin (To glue it all together is ideal).

How to make a spinner

After everything is prepared, let's start manufacturing. Using a step drill, drill a hole of the required diameter for the bearing.
How to make a spinner

We clamp the sleeves into the drill chuck and at low revs, leaning the sandpaper, we begin to grind them until the paint is completely removed.
How to make a spinner

How to make a spinner

From the bearing we remove anthers, we clean it, plentifully sprinkling WD-40
Next, we coat the edges of the bearing with epoxy, press it into the bar, and only after that we drill the side holes for the liners.
This is done in order that the bar would not burst, becauseIn my case, the walls turned out thin.
How to make a spinner

In the end, I still decided to postpone the drill and expand the holes with the help of an engraver for the desired diameter. We glue the sleeves together (the same epoxy resin), we also coat the holes in the bar with epoxy and press the sleeves into place. We leave it all to dry for 6 hours and finally enjoy a simple toy made with our own hands.
How to make a spinner

How to make a spinner

Related news

How to make a spinner image, picture
How to make a spinner 5


How to make a spinner 9


How to make a spinner 30


How to make a spinner 73